Connect-tech BLUESTORM UNIVERSAL PCI CTIM-00015 Manual de usuario descargar pdf (Pagina 11)

BlueStorm Installation Guide, Connect Tech Inc.

Revision 0.08 11

Figure 6: BlueStorm/SP RJ-11 diagram, 8 port model

Note: Refer to Table 8 for port 7 and port 8 pinouts.

Jumper Configuration for BlueStorm

Jumper configurations will vary by model. BlueStorm/LP cards feature the jumper layout listed

in Figure 7, while BlueStorm/SP and BlueStorm/SP Opto cards use the jumper layout in Figure

8. Lastly, BlueStorm/SP RJ-11 uses the jumper layout used in Figure 9.

Figure 7 demonstrates a common set of jumper configurations for a BlueStorm/LP RS-422/485

card. BlueStorm/LP RS-232 ports do not require jumper configuration. The four RS-422/485

ports are set as follows: Port 1 is set for half duplex, Port 2 is set for half duplex, Port 3 is set for

full duplex, and Port 4 is set for multi-drop slave.

Figure 8 indicates a common set of jumper configurations for BlueStorm/SP and BlueStorm/SP

Opto. The four ports are set as follows: Port 1 is set for RS-232, Port 2 is set for half duplex,

Port 3 is set for full duplex, and Port 4 is set for multi-drop slave.

Figure 9 illustrates the jumper configurations for selecting +5V power or +12V power.

6 x RJ-11

Pin 1 Pin 1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Sin comentarios

Connect-tech BLUESTORM UNIVERSAL PCI CTIM-00015 Manual de usuario Pagina 11