
Connect Tech Blue Heat/Net Sync User Manual
60 Revision 0.03
Serial Mode (smode)
BHN_PortSettings
Required [1]: Must be NRZ or NRZ_INV
Optional [1]: Needed if a clocking source feeds either of the Baud Rate Generators. If the Receiver or Transmitter are clocked directly from certain Line
Interface signals (RxC or TxC setup as inputs) and those Interface signals are setup as outputs, then the indicated parameters are required.
Optional [2]: Required only when the DPLL is part of the clocking tree setup.
Optional [3]: Required only when either Counter (CTR-0 or CTR-1) is directly clocking the Receiver, Transmitter, RxC or TxC signals.
Optional [4]: Only required when the clk_tree.A setting is CLK_DPLL (which is generally only used with Synchronous modes).
Optional [5]: Only required when the clk_tree.A or clk_tree.C setting selects a Baud Rate generator.
Optional [6]: Only required if CRC is enabled.
Comentarios a estos manuales