
Xtreme/104 Opto User Manual
CTIM-00007 (0.10) 3/21/2012 www.connecttech.com 22
800-426-8979 | 519-836-1291
Half Duplex RS-422/485
Place jumpers on positions A and C of jumper blocks JB4, JB5, JB6 and JB7 to run the
individual RS-422/485 ports in half duplex mode. In this mode your Xtreme/104 Opto
adapter controls the transmitter and receiver circuits. RTS is turned on prior to and during
transmission to cause the transmit driver to enable and the receiver to disable. RTS is
turned off when not transmitting to cause the transmit driver to disable (tri-stated) and the
receiver to enable. The Xtreme/104 Opto adapter is responsible for timing the RTS toggle.
See Figure 1 and Figure 2 for jumper block locations.
Figure 10: Half Duplex Mode Jumper Setting Example
In the following example, Ports 1 and 2 are set for half duplex mode. Ports 3 and 4 are
RS-232 and therefore should not be set for half duplex.
Note: Rev A & B Xtreme/104 Opto adapters do not have
positions H & I on jumper blocks, JB4, JB5, JB6, and JB7
Jumper Legend
(Rev. C & later adapters)
A = TxD control
B = RS-232/RS-422/485
select
C = RxD control
D = RTS terminator
E = TxD terminator
F = RxD terminator & bias
G = RxD terminator & bias
H = CTS terminator & bias
I = CTS terminator & bias
Jumper Legend
(Rev. A & B adapters)
A = TxD control
B = RS-232/RS-422/485
select
C = RxD control
D = RTS terminator
E = TxD terminator
F = CTS terminator
G = RxD terminator
NOTE:
J1 controls ports 1 and 2 and J2 controls ports 3 and 4. If both ports 1 and 2 are
set for full duplex then J1 should not be jumpered. If both ports 3 and 4 are set
for full duplex then J2 should not be jumpered.
Comentarios a estos manuales