Connect Tech JB2 Manual de usuario descargar pdf (Pagina 9)

Xtreme/104 Opto User Manual

9 www.connecttech.com CTIM-00007 (0.10) 3/21/2012

800-426-8979 | 519-836-1291

Hardware Installation

Installing the Xtreme/104 Opto Into Your System

Before you begin, take a minute to ensure that your package includes the required

components.

 One Xtreme/104 Opto board

 One CD containing software and documentation

 One DB-9 cable (optional)

If any of these components is missing, contact Connect Tech or your reseller.

For ease of installation, be sure you have configured all jumpers prior to adding the

Xtreme/104 Opto to your PC/104 stack (See Hardware Configuration section).

Hardware Configuration

Port Addresses

Port addresses are configured with jumper block JB3 on the Xtreme/104 Opto adapter.

Jumpers A, B, and C select a set of port addresses for the ports.

Status Port

Some operating system device drivers can utilize an Interrupt Status Port. Use of the

Interrupt Status Port can improve your system’s efficiency. The Xtreme/104 Opto offers a

status port and this port is enabled and disabled using jumper F on jumper block JB3.

Please refer to Table 1 for a list of supported status port addresses and to Figure 1 and

Figure 2 for a description and location of jumper block JB3.

Technical Tip:

Please make certain the Status Port Enable jumper is disabled if

your application does not use the Status Port. This eliminates the

possibility of an address conflict with another device in your

system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sin comentarios

Connect Tech JB2 Manual de usuario Pagina 9